Sold Out

Pharma Mix-3

$129.00

Brand: Pharmacom Labs
Category: Injectable Steroids
Substance: Testosterone Enanthate, Trenbolone Enanthate, Nandrolone Decanoate
Package: 10ml vial (500mg/ml)

Out of stock

Description

How to administer Pharma Mix-3

If an athlete is about to start his first cycle with anabolic steroids, “how to inject” is probably the last thing that bothers him. Usually beginners study the instructions of anabolic steroids, availability on the market, and choose those that they think can help achieve the goal. But when a novice body builder has a syringe and vials for the first time in his hands, the first thing that comes to mind is how to get this steroid out of the bottle and inject it into the body.

At this stage, athletes are often annoyed and even give up. Here is some useful information about the introduction of anabolic steroids.

Draw some air into the syringe and put it into the vial. The pressure in the bottle will increase, and it will be easier to draw out the liquid from it. Gather the required volume of fluid with a small margin. Another way is to insert the needle into the vial, turn it upside down and fill the syringe with the required amount of liquid. Also with a small margin. Then you need to tap your finger on the syringe so that the air rises to the top of the syringe. After that, the syringe is inserted back into the vial and the air and excess liquid are released from it.

Some bodybuilders change the needle, as it may have lost some of its sharpness when it fits through the cork. Such a needle can cause some discomfort when piercing the skin.

If a little liquid has spilled from the needle, do not try to touch or even erase it.

The area into which injections will be injected should be rubbed with alcohol using a cotton pad or tampon. Then the needle is injected by pressing a hand at an angle of 90 degrees. It must fully enter the body. If you notice blood inside the syringe, you are probably caught in a vein or artery. You need to choose another place for the injection and repeat the procedure again. If there is no blood, slowly, so that there is no pain, push down on the needle until all the liquid gets into the muscle.

After a few seconds, pull the needle and immediately cover the injection area with a fresh cotton swab and hold it for a few seconds. If there is some blood on the swab, everything is in order. You just pierced the skin, and some blood must come out.

Additional information

Brand

Substance

Package